[vtkusers] vtkSTLWriter strongly confusing behavior

[Dominik Szczerba]

You may be right, but then I would still argue the reader should not do 
it as it does not read the actual mesh in the file - this is not less 
confusing. Agree?

- Dominik

Frederic Danesi wrote:
> I think that there is no such thing as merging in the STLWriter, since a STL
> file is basically only the coordinates of the points, without any ID.
> The merging operation probably happen when you load your STL, since the
> coincident points have the same coordinates and are thus considered as
> unique point ...
> Fred.
> 
> Cordialement,
> F.Danesi


-- 
d o m i n i k   s z c z e r b a ,   p h d . . . . . . . . . . .
c o m p u t a t i o n a l   l i f e   s c i e n c e   g r o u p
. . . . . . . i t ' i s   r e s e a r c h   f o u n d a t i o n
. . . . . . . . . . . . . . . . . . . . http://www.itis.ethz.ch