[vtkusers] vtkTubeFilter / cylinder with steps

[David.Pont at ensisjv.com]

binesh r <binesh01 at yahoo.com> wrote on 18/08/2006 04:09:44:

> Is it possible to use a single vtktubefilter to represent a stepped
> cylinder?.How do I specify 2 radii at the same location along the
> axis in such a case? I may do it with a slight taper, a solution i
> would like to avoid.

If you duplicate the point so it has the same location but a different
scalar it should work in theory? but not sure how the tube filter will
cope. Of course the new point will have to be inserted correctly in
sequence with the existing points.
   Dave P

> Thanks,
> Binesh
> __________
> |                 |
> |                 |_________
> |                                  |
> |                  ________  |
> |                 |
> |_________ |
>  How low will we go? Check out Yahoo! Messenger’s low PC-to-Phone call
rates.
> _______________________________________________
> This is the private VTK discussion list.
> Please keep messages on-topic. Check the FAQ at: http://www.vtk.
> org/Wiki/VTK_FAQ
> Follow this link to subscribe/unsubscribe:
> http://www.vtk.org/mailman/listinfo/vtkusers
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vtk.org/pipermail/vtkusers/attachments/20060818/299c7290/attachment.htm>