[vtkusers] stretching along an axis

[Burlen]

Are you using the axis actor 2d? If not then you should try to use it instead 
of the pre-packagaed axis. You will need three of them, but you can set the 
range independant of the position coordinates.

On Sunday 02 January 2005 18:31, Tom Adelman wrote:
> I would like to stretch an entire plot along an axis,
> but I can’t figure out how to do this.  More
> specifically, when rendering a volume that has unequal
> proportions, with the following ranges x(0, 10), y(0,
> 10), and z(0, .1), the image is very flat.  I could
> stretch this out by multiplying all z-values by 100,
> but then it’s difficult to read numbers off the axis,
> or present and publish the figure.
>
> Is there a way to get the axis to read the correct
> numbers and also have axes with equal proportions in
> the visualization?
>
> Thanks,
> Tom
>
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Send holiday email and support a worthy cause. Do good.
> http://celebrity.mail.yahoo.com
> _______________________________________________
> This is the private VTK discussion list.
> Please keep messages on-topic. Check the FAQ at:
> http://www.vtk.org/Wiki/VTK_FAQ Follow this link to subscribe/unsubscribe:
> http://www.vtk.org/mailman/listinfo/vtkusers