[vtkusers] problem with POSIX threads

[Song Li]

Hi, gurus,
   my program use VTK and other software libraries on SGI platform, it
works fine when I use libraries with sproc mode, but after I switch to
use POSIX-mode library, the program can not work, I doubt that VTK cause
the problem, anybody can tell me if VTK can also support these two modes
and how to switch between them ??(Makefile available??)
  Thanks a lot!

--
Song Li
VRAC(Virtual Reality Application Center),Iowa State University
Email: lisong at vrac.iastate.edu
Homepage: http://www.vrac.iastate.edu/~lisong


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vtk.org/pipermail/vtkusers/attachments/20020204/cf150f8c/attachment.htm>