[vtkusers] problem with POSIX threads

[David Gobbi]

Hi Song,

You can only use POSIX threads with IRIX 6.5 or later.  If you
are not using IRIX 6.5, you might want to upgrade.

 - David


On Mon, 4 Feb 2002, Song Li wrote:

> Hi, gurus,
>    my program use VTK and other software libraries on SGI platform, it
> works fine when I use libraries with sproc mode, but after I switch to
> use POSIX-mode library, the program can not work, I doubt that VTK cause
> the problem, anybody can tell me if VTK can also support these two modes
> and how to switch between them ??(Makefile available??)
>   Thanks a lot!
>
> --
> Song Li
> VRAC(Virtual Reality Application Center),Iowa State University
> Email: lisong at vrac.iastate.edu
> Homepage: http://www.vrac.iastate.edu/~lisong
>
>
>