[Paraview] LOD not working?

[Peter J. Bismuti]

I've created a sphere with 100x100 resolution.
Set sphere representation to wireframe. 
Set LOD resolution to 10x10x10.
Set LOD threshold to 0.  

When I rotate the sphere I still don't see LOD.

Thx  


> What is the LOD resoultion?
> Try setting LOD resolution to 10x10x10 (slider to the right).
> Any improvement?
>
> If still no change, just for a sanity check try this:
> * create a simple source, say sphere.
> * set Theta Resolution to 100
> * set Phi Resolution to 100
> * set [Display Tab] | Representation to "Wireframe"
> Now try interacting. Are you seeing a simplified sphere while interacting?
>
> Utkarsh.
>
> Peter J. Bismuti wrote:
> > I've set all of the threshold controls for LOD very low but cannot get it
> > to kick in.  For example,  the representation of the surface geometry
> > attached will not change when rotating and therefore is very slow.  Can
> > anyone tell me what I'm doing wrong?   Thanks
> >
> >
> >
> >
> > ------------------------------------------------------------------------
> >
> >
> > ------------------------------------------------------------------------
> >
> > _______________________________________________
> > ParaView mailing list
> > ParaView at paraview.org
> > http://www.paraview.org/mailman/listinfo/paraview

-- 


Peter Bismuti
Boeing Commercial Airline Division
Shared Services
Renton, WA
(425) 234-0873