[vtkusers] SGI Open Inventor file .iv?

[Mathieu Malaterre]

did you read the following post:

http://www.vtk.org/pipermail/vtkusers/2004-December/077855.html

else I would use ivcon

http://people.sc.fsu.edu/~burkardt/cpp_src/ivcon/ivcon.html

cheers

On Mon, Oct 19, 2009 at 8:09 PM, Dongqing Chen
<dqchen at cvip.louisville.edu> wrote:
> Dear All:
>
>      I just got some SGI open inventor files, with extension iv, which are a
> little bit old. I may ask if VTK supports .iv file. Or is there any free
> software available to open and view those files.
>
>      Thank you.
>
> Best Wishes,
> -----------------------------------------------------------------------------
> Dongqing Chen, Ph.D.
> Computer Vision & Image Processing (CVIP) Lab
> Department of Electrical & Computer Engineering
> Speed School of Engineering
> University of Louisville
> Louisville, KY, 40292
> U.S.A
> email: dqchen at cvip.louisville.edu
> phone: 1-502-852-2789 (Lab)
>              1-502-852-6130 (Office)
> ----------------------------------------------------------------------------
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the VTK FAQ at:
> http://www.vtk.org/Wiki/VTK_FAQ
>
> Follow this link to subscribe/unsubscribe:
> http://www.vtk.org/mailman/listinfo/vtkusers
>
>



-- 
Mathieu