[vtkusers] closed meshes from vtkDiscreteMarchingCubes?

[Dominik Szczerba]

You can of course close the holes with a filter, but you can also pad 
the image to be contoured to avoid their formation.
- Dominik

lynx.abraxas at freenet.de wrote:
> Hello!
> 
> 
> Looking  at  my  meshes  from vtkDiscreteMarchingCubes in blender it seems the
> meshes are open where a label touched  the  border  of  the  3D-image.  Is  it
> possible to close these meshes with a plane?
> I'm asking because I'd like to use vtkMassProperties on each labeled mesh.
> If  that  is  not  possible:  Is  there a function that evaluates if a mesh is
> closed? I just  found  vtkSelectEnclosedPoints  that  seems  to  contain  this
> functionality. But there seems to be no GetResultFromCheckSurface.
> 
> Thanks for any hints or help.
> Lynx
> 
> _______________________________________________
> Powered by www.kitware.com
> 
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
> 
> Please keep messages on-topic and check the VTK FAQ at: http://www.vtk.org/Wiki/VTK_FAQ
> 
> Follow this link to subscribe/unsubscribe:
> http://www.vtk.org/mailman/listinfo/vtkusers
> 


-- 
d o m i n i k   s z c z e r b a ,   p h d . . . . . . . . . . .
c o m p u t a t i o n a l   l i f e   s c i e n c e   g r o u p
. . . . . . . i t ' i s   r e s e a r c h   f o u n d a t i o n
. . . . . . . . . . . . . . . . . . . . http://www.itis.ethz.ch