[vtkusers] 3D Rendering of an sliced object

[OnezerO]

I did that a long time ago and didnt work :) 

-----Mensaje original-----
De: Kevin H. Hobbs [mailto:kevin.hobbs.1 at ohiou.edu] 
Enviado el: Martes, 08 de Noviembre de 2005 13:53
Para: OnezerO
Asunto: Re: [vtkusers] 3D Rendering of an sliced object

On Tue, 2005-11-08 at 12:00 -0300, OnezerO wrote:
>  
> Hello, i'm send this post again because i think that i dont explain my 
> problem very well... I have a series of images that represents a 3d 
> figure, this images was preprocesing with itk i'm receiving it with a 
> Importer from vtk, i pass the data throught a Contourfilter and then 
> by a SmoothFilter, the resulting 3d images has openings upside and 
> downside, i wanna close this holes... how i do it???
>  
> Regards
>  
> 

You could just add all black slices above and below.  This would do the same
thing as padding, that is cap the surface.