[vtkusers] run time error on "volProSimple.tcl"

[Pairash Saiviroonporn]

Hi Lisa
   Thanks for your advices. Yes it is running ok if I change the
vtkVolumeProMapper to a vtkVolumeTextureMapper2D. I think that the vli
I used is ok with the driver because I can run the vli test program.
However, are there anyways to check it out?
Thanks a lot, pai.

On Tue, 23 Oct 2001, Lisa Sobierajski Avila wrote:

> Hello Pairash,
> 
> If you change the vtkVolumeProMapper to a vtkVolumeTextureMapper2D in the 
> script, does it run? (This will eliminate errors reading the data or 
> problems with the installation). Next, are you certain that the vli you 
> compiled against is compatible with the driver you are running?
> 
> Lisa
> 
> 
> At 08:59 PM 10/22/2001, Pairash Saiviroonporn wrote:
> >Hi There
> >    I would like to ask for some helps with problem on run time
> >error when running "volProSimple.tcl"
> >
> >    I just installed VolPro500 card on my SUN Ultra-80 Solaris 5.8. Here
> >what I did:
> >    - complete install driver software and can run test programs ok
> >      (31 fps for 128x128x128 data set)
> >    - complie vtk (using SUNWS CC 6.1) with VolumePro classes (just
> >followed steps in vtkVolumeProVG500Mapper.h)
> >
> >    However when I tested vtk on volProSimple.tcl, I got:
> >
> >(75)laser3d: /export/laser/bay3_project/vtk_laser/tcl/vtk volProSimple.tcl
> >
> >Segmentation fault
> >
> >  Have anyone experiences this problem before? Any helps you can give will
> >be really appriciate.
> >
> >Thanks, pai.
> >
> >
> >_______________________________________________
> >This is the private VTK discussion list.
> >Please keep messages on-topic. Check the FAQ at: 
> ><http://public.kitware.com/cgi-bin/vtkfaq>
> >Follow this link to subscribe/unsubscribe:
> >http://public.kitware.com/mailman/listinfo/vtkusers
> 
> 
>