[vtkusers] run time error on "volProSimple.tcl"

Lisa Sobierajski Avila lisa.avila at kitware.com
Tue Oct 23 01:21:57 EDT 2001


Hello Pairash,

If you change the vtkVolumeProMapper to a vtkVolumeTextureMapper2D in the 
script, does it run? (This will eliminate errors reading the data or 
problems with the installation). Next, are you certain that the vli you 
compiled against is compatible with the driver you are running?

Lisa


At 08:59 PM 10/22/2001, Pairash Saiviroonporn wrote:
>Hi There
>    I would like to ask for some helps with problem on run time
>error when running "volProSimple.tcl"
>
>    I just installed VolPro500 card on my SUN Ultra-80 Solaris 5.8. Here
>what I did:
>    - complete install driver software and can run test programs ok
>      (31 fps for 128x128x128 data set)
>    - complie vtk (using SUNWS CC 6.1) with VolumePro classes (just
>followed steps in vtkVolumeProVG500Mapper.h)
>
>    However when I tested vtk on volProSimple.tcl, I got:
>
>(75)laser3d: /export/laser/bay3_project/vtk_laser/tcl/vtk volProSimple.tcl
>
>Segmentation fault
>
>  Have anyone experiences this problem before? Any helps you can give will
>be really appriciate.
>
>Thanks, pai.
>
>
>_______________________________________________
>This is the private VTK discussion list.
>Please keep messages on-topic. Check the FAQ at: 
><http://public.kitware.com/cgi-bin/vtkfaq>
>Follow this link to subscribe/unsubscribe:
>http://public.kitware.com/mailman/listinfo/vtkusers





More information about the vtkusers mailing list