Connectivity and Streamlines

[Josh Cantu]

hello vtkusers,

    i have a modeled geometry that has been meshed in three seperate
sections,  the streamlines
are only being created up to the end of each section then you must
specify a point or a line to
create the streamlines in the next section.  i would like to have the
streamlines go through the
entire geometry.  would the connectivity filter work in this case?? or
does anyone have another
suggestion. thanks

josh cantu
iowa state university
research assistant



-----------------------------------------------------------------------------
This is the private VTK discussion list.  Please keep messages on-topic.
Check the FAQ at: <http://www.automatrix.com/cgi-bin/vtkfaq>
To UNSUBSCRIBE, send message body containing "unsubscribe vtkusers" to
<majordomo at gsao.med.ge.com>.  For help, send message body containing
"info vtkusers" to the same address.     Live long and prosper.
-----------------------------------------------------------------------------