[Paraview] Broken Streamlines

[Berk Geveci]

Hey Louis,

Can you provide the data and example script?

Best,
-berk

On Wed, Feb 7, 2018 at 12:06 PM, Steytler, Louis Louw <steytle1 at illinois.edu
> wrote:

> Hi Everyone,
>
> When generating streamlines from a 3D computation, in some parts, the
> streamlines appear broken. This is shown in the attached image (the arrows
> point to the broken parts).
>
> Increasing the "Maximum Streamline Length" parameter did not help.
>
> Using the "Point to Cell Data" filter, and then generating streamlines on
> the cell data did not help.
>
> Although in the image shown the broken parts are in an area of low
> velocity, this happens in regions of high velocity as well. It also does
> not seem to depend on grid resolution, as the broken parts show up all over.
>
> Has anyone experienced anything like this? Any ideas how to work around
> this?
>
> Thanks very much,
>
> Louis Steytler
> Department of Mechanical Science and Engineering
> University of Illinois at Urbana-Champaign
> 1206 West Green Street
> Urbana, Il 61801
> steytle1 at illinois.edu
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/
> opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Search the list archives at: http://markmail.org/search/?q=ParaView
>
> Follow this link to subscribe/unsubscribe:
> https://paraview.org/mailman/listinfo/paraview
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://paraview.org/pipermail/paraview/attachments/20180207/4591bc41/attachment.html>