[Paraview] Installing paraviewweb on a raspberry pi

[Scott Wittenburg]

I would think you'd want to build with:

PARAVIEW_BUILD_QT_GUI=OFF

Hope this helps,

Scott

On Fri, Feb 10, 2017 at 2:25 PM, Faraz Hussain <info at feacluster.com> wrote:

> Thanks for your help in installing Paraview on a raspberry pi. I followed
> the steps in:
>
> http://www.paraview.org/Wiki/ParaView:Build_And_Install
>
> However, when I configure ccmake it says QT is needed. I could not figure
> out if I can ignore that. The "generate" command did not come up.
>
> On a side note, it took me a while to find ccmake. I thought it was
> installed with cmake, but seems I had to install it separately using "sudo
> apt-get install cmake-curses-gui" . Perhaps the instructions should be
> updated to reflect this to avoid confusion.
>
>
> Quoting Sebastien Jourdain <sebastien.jourdain at kitware.com>:
>
> Wow,
>>
>> I'm not an expert on raspberry pi but it should be possible.
>> BUT, (and it is a big but) you need some graphics capability for ParaView
>> or good CPUs if you don't have a GPU.
>> Or the rendering will be really slow.
>>
>> The quicker test you can do, is to build ParaView (without Qt) and try to
>> run Visualizer with that ParaView in the command line to see what
>> performance you are getting. If that's reasonable, then all the network
>> setup should be "trivial".
>>
>> ParaView: http://www.paraview.org/Wiki/ParaView:Build_And_Install
>> Visualizer: https://kitware.github.io/visualizer/
>>
>> Good luck,
>>
>> Seb
>>
>> On Wed, Feb 8, 2017 at 8:15 AM, Faraz Hussain <info at feacluster.com>
>> wrote:
>>
>> I want to be able to manipulate vtk file on my raspberry pi via a web
>>> browser anywhere in the world. I believe I need to install paraviewweb
>>> and
>>> do some reconfiguration of apache and the virtual hosts? Unfortunately, I
>>> am not a guru of Linux. So before I attempt it all, is it even possible
>>> to
>>> do this on a raspberry pi? I am using raspian .
>>>
>>> _______________________________________________
>>> Powered by www.kitware.com
>>>
>>> Visit other Kitware open-source projects at
>>> http://www.kitware.com/opensou
>>> rce/opensource.html
>>>
>>> Please keep messages on-topic and check the ParaView Wiki at:
>>> http://paraview.org/Wiki/ParaView
>>>
>>> Search the list archives at: http://markmail.org/search/?q=ParaView
>>>
>>> Follow this link to subscribe/unsubscribe:
>>> http://public.kitware.com/mailman/listinfo/paraview
>>>
>>>
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensou
> rce/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Search the list archives at: http://markmail.org/search/?q=ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/paraview
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/paraview/attachments/20170210/83a22453/attachment.html>