[Paraview] using calculator filter on a table?

[Joshua Murphy]

Hi Utkarsh,

I have tried this once again in v4.2.0, and I am getting the same segfault.

any thoughts? my input is a multi-block table...

-Josh

________________________________________
From: Utkarsh Ayachit [utkarsh.ayachit at kitware.com]
Sent: Thursday, September 25, 2014 11:23 AM
To: Joshua Murphy
Cc: paraview at paraview.org
Subject: Re: [Paraview] using calculator filter on a table?

For now, with 4.2 RC1, stick to using "Programmable Filter" with
"Script" as follows:

expr = inputs[0].RowData["RTData"] * 2.0
output.RowData.append(expr, "result")

If you can add a bug to the bug tracker for this, that'd be great too.

Thanks
Utkarsh

On Thu, Sep 25, 2014 at 12:45 PM, Joshua Murphy
<Joshua.Murphy at lasp.colorado.edu> wrote:
> Hello all,
>
> Is there a way to use the Calculator filter on a table?
>
> My reader loads a bunch of auxiliary files that loads time-series information for a specific point (at a higher temporal resolution than the 3D model output).  I need to be able to convert the units in the time series information with some simple calculations so that I can match the units of the remainder of my work.
>
> Is there a way to use the calculator filter to do this? It is greyed out when I have the table selected...  Are there some other steps I need to do to make it work?
>
> Thanks,
> Josh
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/paraview