[Paraview] PV 3.14.1 64-bit trace save data question

[Utkarsh Ayachit]

Yes, that's as expected, at least in 3.14. Support for that was added
later, if I remember correctly.

On Mon, May 6, 2013 at 8:39 AM, Stephen Wornom <stephen.wornom at inria.fr> wrote:
> After load the PV file (.pvtu)
> 1-I turn on trace
> do slice, clip, then contour
> save data
> 2-I turn off trace
> save the trace.py file
> When I edit the trace.py file everything is there EXCEPT the save data
> command.
> Is this normal?
> Thanks in advance,
> Stephen
>
> --
> stephen.wornom at inria.fr
> 2004 route des lucioles - BP93
> Sophia Antipolis
> 06902 CEDEX
>
> Tel: 04 92 38 50 54
> Fax: 04 97 15 53 51
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>