[Paraview] Outline in Slice View

[Moreland, Kenneth]

Ah, right you are!  I hadn't even noticed that new view.

I'm guessing no one has thought of that yet.  I raised a bug report about
it:

http://www.paraview.org/Bug/view.php?id=13791

-Ken



On 1/15/13 8:26 AM, "Michael Reuter" <reuterma at ornl.gov> wrote:

>The Slice View doesn't show any outlines around the individual planes
>(see attached plot), so that isn't an option. I was talking about the
>outline on the bounding box.
>
>Thanks,
>M
>
>
>On 1/15/13 10:09 AM, "Moreland, Kenneth" <kmorel at sandia.gov> wrote:
>
>>Did you try clicking off the checkbox labeled "Show Plane" in the
>>Properties panel?
>>
>>-Ken
>>
>>
>>
>>On 1/15/13 7:53 AM, "Reuter, Michael A." <reuterma at ornl.gov> wrote:
>>
>>>Hi,
>>>
>>>Is there an option to turn off the outline shown in the Slice View? If
>>>not, can one be added?
>>>
>>>Thanks,
>>>M
>>>
>>>Dr. Michael Reuter
>>>Data Analysis and Visualization Group
>>>Neutron Data Analysis and Visualization Division
>>>Oak Ridge National Laboratory
>>>
>>>Office: 1-865-241-7216
>>>Fax: 1-865-574-6080
>>>Email: reuterma at ornl.gov
>>>_______________________________________________
>>>Powered by www.kitware.com
>>>
>>>Visit other Kitware open-source projects at
>>>http://www.kitware.com/opensource/opensource.html
>>>
>>>Please keep messages on-topic and check the ParaView Wiki at:
>>>http://paraview.org/Wiki/ParaView
>>>
>>>Follow this link to subscribe/unsubscribe:
>>>http://www.paraview.org/mailman/listinfo/paraview
>>>
>>
>>
>