[Paraview] [Paraview-developers] Paraview with python problem

[Utkarsh Ayachit]

Gerald,

Since you compiled from source, can you do debug build and then run
through a debugger to see why it's aborting? I don't think I've seen
this behaviour before. I wonder if its related to the dependency
issue. Was this a clean build or were you doing an incremental build?

Utkarsh

On Wed, Dec 18, 2013 at 9:19 AM, Lodron, Gerald
<Gerald.Lodron at joanneum.at> wrote:
> Hi
>
>
>
> I successfully compiled paraview 4.1.0 with python 2.7.3 enabled in 32 bit.
> Paraview also starts but when I generate ANY data (over open file or over
> sources->Sphere or box or anything else etc.) it closes after pressing
> Apply. Does anyone has a clue what could cause that strange behaviour?
>
>
>
> Thanks for advice…..
>
>
>
> Best regards
>
> Gerald Lodron
>
>
>
> _________________________________________________________________
>
>
>
> JOANNEUM RESEARCH Forschungsgesellschaft mbH
>
>
>
> DIGITAL – Institute for Information and Communication Technologies
>
> Steyrergasse 17, 8010 Graz, Austria
>
>
>
> phone: +43 316 876-1751
>
> fax: +43 316 8769-1751
>
> e-mail: gerald.lodron at joanneum.at
>
> web: www.joanneum.at/digital
>
> _________________________________________________________________
>
>
>
> This message and any attached files are confidential and intended solely for
> the addressee(s). Any publication, transmission or other use of the
> information by a person or entity other than the intended addressee(s) is
> prohibited. If you receive this in error please contact the sender and
> delete the material. The sender does not accept liability for any errors or
> omissions as a result of the transmission.
>
>
>
> Please consider the environment before printing this page.
>
>
>
>
>
>
> _______________________________________________
> Paraview-developers mailing list
> Paraview-developers at paraview.org
> http://public.kitware.com/mailman/listinfo/paraview-developers
>