[Paraview] Paraview with python problem

[Lodron, Gerald]

Hi

I successfully compiled paraview 4.1.0 with python 2.7.3 enabled in 32 bit. Paraview also starts but when I generate ANY data (over open file or over sources->Sphere or box or anything else etc.) it closes after pressing Apply. Does anyone has a clue what could cause that strange behaviour?

Thanks for advice.....

Best regards
Gerald Lodron

_________________________________________________________________

JOANNEUM RESEARCH Forschungsgesellschaft mbH

DIGITAL - Institute for Information and Communication Technologies
Steyrergasse 17, 8010 Graz, Austria

phone: +43 316 876-1751
fax: +43 316 8769-1751
e-mail: gerald.lodron at joanneum.at<mailto:gerald.lodron at joanneum.at>
web: www.joanneum.at/digital<http://www.joanneum.at/digital>
_________________________________________________________________

This message and any attached files are confidential and intended solely for the addressee(s). Any publication, transmission or other use of the information by a person or entity other than the intended addressee(s) is prohibited. If you receive this in error please contact the sender and delete the material. The sender does not accept liability for any errors or omissions as a result of the transmission.

Please consider the environment before printing this page.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20131218/e631d3d6/attachment.htm>