[Paraview] Debugging Why STL file will not load

[Robert Maynard]

Hi,

The current STL reader has no debug information to tell you why it failed to
read a file. If you are able to send me the file I can look into why the
reader fails.

On Mon, May 30, 2011 at 9:47 AM, Michael Jackson <
mike.jackson at bluequartz.net> wrote:

> I am creating an STL Binary file from another program. I am then trying to
> load it in ParaView. ParaView seems to recognize the STL file but after I
> load it nothing appears. I click on the "Information" tab and it says
> Polygonal Mesh but 0 cells and 0 points. There are no error messages or
> anything else. Is there something I can enable to try and figure out why
> nothing is showing up or the read is failing?
>
> Thanks
> ___________________________________________________________
> Mike Jackson                      www.bluequartz.net
> Principal Software Engineer       mike.jackson at bluequartz.net
> BlueQuartz Software               Dayton, Ohio
>
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>



-- 
Robert Maynard
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20110530/c2c1fc9d/attachment.htm>