[Paraview] DIY Application problem

[Utkarsh Ayachit]

Is it possible to share you code? Pretty sure you are missing an
equivalent of "accept" somewhere.

Utkarsh

On Fri, Mar 4, 2011 at 10:32 AM, Reuter, Michael A. <reuterma at ornl.gov> wrote:
> Hi,
>
> I'm trying to get the DIY application up and running. I have successfully got it to compile and run, but it doesn't seem to do anything when loading the sample data. At first I thought that it was due to not having a running server before loading the file, so I created a server instance, connected the client and then loaded the data again. In spite of this, nothing shows up on the screen and none of the drop down boxes show anything interesting. I'm not receiving any error messages from the program. I can load the sample data into ParaView just fine. Is there a debug flag I can set or pass to the DIY program to get some information about what is going on?  I am running on 64-bit Ubuntu with a git copy of ParaView.
>
> Thanks,
> Michael
>
>
> Dr. Michael Reuter
>
> Scientific Data Analysis Group
>
> Neutron Scattering Science Division
>
> Oak Ridge National Laboratory
>
>
> Office: 1-865-241-7216
>
> Fax: 1-865-574-6080
>
> Email: reuterma at ornl.gov
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>