[Paraview] Selected point size/location problems

[David Doria]

Here is the procedure to generated the issue:

1) Add a cone source
2) Use select points on to select on of the points. (
http://www.rpi.edu/~doriad/Paraview_List/Selection/setup.png)
3) zoom in to the point you selected. You will see that it is not actually
on the corner where it should be (
http://www.rpi.edu/~doriad/Paraview_List/Selection/surface.png). Why is
this?
4) Change the cone's representation from 'surface' to 'points'. You will see
that the two points do not coincide. (same problem as in #3)
5) Change the point size. You will see that the white point gets bigger, but
the selected (pink)point is still very small (
http://www.rpi.edu/~doriad/Paraview_List/Selection/pointsize.png). Is there
a way to change this? Shouldn't it be changing the color of the actual point
anyway instead of adding a new point?

Any thoughts on this?

Thanks,

David
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20091103/a55685f4/attachment.htm>