[Paraview] plugin for 3D Delaunay

[Stefan Murphy]

I have installed CMake, and Qt 4.3.3 from the file
qt-win-opensource-4.3.3-mingw. MinGW was installed with Qt. I obtained
the source code for ParaView3.2.1.

When I try to run CMake for Visual Studio 9, 2008 it says that Qt is
not found, specifically asking me to check the QT_QMAKE_EXECUTABLE
variable. I set this to C:\Qt\4.3.3\bin, but I get the same error.

Is there anything else I have to do with Qt? I ran "configure
-platform win32-g++" and added C:\Qt\4.3.3\bin to PATH and still get
the same error.


Stefan



On Feb 18, 2008 6:24 PM, Jean Favre <jfavre at cscs.ch> wrote:
> On 18, Feb 2008 10:48 PM, Stefan Murphy <stefan.murphy at dal.ca> wrote:
>
> >Jean,
> >
> >I've been trying to compile your plugin with CMake, but I am getting
> >the error:
> >
> >"CMake Error: ParaView_DIR is not set. It must be set to the directory
> >containing ParaViewConfig.cmake in order to use ParaView."
> >
> >I have never used CMake before - Do you have the compiled .dll or .so
> >file for the plugin?
>
> the procedure documented on the Wiki assumes prior knowledge of Cmake,
> and assumes that you have compiled your own version of ParaView from the
> source code distribution.
>
> The error above comes up the first time you run cmake while its internal
> variables are not set. While using Cmake, you should put in the path to
> the directory where you have previoulsy build ParaView. After that, the
> configuration can complete, and the Makefile gets generated.
>
> Looks however, like you have never done any of this. First step, check
> the wiki, compile your own Paraview. Once done with that, you may get to
> the second step of adding pluggins.
>
> Jean
>
>