[Paraview] Re: Question on file format

[Alberto Fernandez]

Thanks a lot guys!!!!
I have been taking a look at ensight format and it is also close to the 
format on our CFD. I think it going to work ok (at least for the moment 
that we just want a quick and dirty solution)
thanks again

Dominik Szczerba escribió:
> in VTK format yes, not sure about Ensight.
>
> Alberto Fernandez wrote:
>   
>> That would force me to store the mesh in each file too wouldn't it?
>> thanks
>>
>> Dominik Szczerba escribió:
>>
>>     
>>> If you store your time steps with systematically increasing suffixes
>>> (.01.vtk 02.vtk etc) PV will recognize them and allow you to chose the
>>> time step with a slider. VTK formats do not offer other possibilities.
>>> You may want to look into the Ensight format which supports time step
>>> data natively.
>>> Dominik
>>>
>>> Alberto Fernandez wrote:
>>>  
>>>
>>>       
>>>> Hello,
>>>>
>>>> I'm writing a parse for a CFD program that we use. The idea is
>>>> converting the results file to Paraview. I have been successful creating
>>>> a parallel file for the unstructured grid and the file with the grid. I
>>>> other words, I can put my geometry in Paraview. What I would like to do
>>>> is to create a results file for each time step. This files should not
>>>> have the information about the mesh since it does not change, just the
>>>> results. Is this possible at all? If it is, please can you direct me a
>>>> little into how to do it. I have tried adding pieces to the parallel
>>>> file but then I get error saying that I do not have points. If what I
>>>> want is not possible, what strategy would you recomend, putting
>>>> everything in the same file?
>>>> Thank you a lot for your time.
>>>>
>>>>     
>>>>         
>>>   
>>>       
>>     
>
>   

-- 
Alberto Fernández
alberto at cognitdesign.com

Cognit Design
C/Arquitecte Sert, 31 Local 3    
Vila Olímpica
08005  Barcelona
Telf: 93 532 29 94
Fax: 93 531 59 42