[Paraview] Cut Offset Values

[Thierry Dubuis]

Hello,

You have right the cut sphere is build but there is a problem with the
range.
For example I have a torus with Radius min = 0.006 and radius max =0.01
I build a cut sphere with a radius = 0.006
I define offset value about 7e-5 to have a cut at radius = 0.01
Why? for me with this offset the radius of the second cut would be 0.00607
and not 0.01.
Have you an explanation about this ?

Thanks for your help.
-----------------------------------------------------
Thierry Dubuis
Sciences & Computer Consultants
Tel Dir  : 04 77 49 75 84
Tel Std : 04 77 49 75 80
----- Original Message -----
From: "Berk Geveci" <berk.geveci at gmail.com>
To: "Thierry Dubuis" <tdubuis at scconsultants.com>
Cc: <paraview at paraview.org>
Sent: Monday, February 07, 2005 3:18 PM
Subject: Re: [Paraview] Cut Offset Values


> Can you elaborate a bit? It works ok for me. I believe the offset
> value is the distance from the surface of the actual sphere. I didn't
> check but the default range provided by paraview might be wrong. If
> this is the case, please file a bug report here:
>
> http://www.paraview.org/Bug/
>
>
> On Mon, 7 Feb 2005 14:14:53 +0100, Thierry Dubuis
> <tdubuis at scconsultants.com> wrote:
> >
> > Hello,
> >
> > I try to use Cut Offset values to define multiple cut spheres with
centered
> > shifted.
> > As it's explain page 219 of "The ParaView Guide" but I can't.
> > The cut planes are Ok but not the Cut spheres.
> >
> > Is it a definition or visualisation problem ?
> > Could you explain me which parameter change between 2 "multiple cuts" ?
(For
> > the cut plane, it's the center)
> >
> > Thanks for your help.
> > -----------------------------------------------------
> > Thierry Dubuis
> > Sciences & Computer Consultants
> > Tel Dir  : 04 77 49 75 84
> > Tel Std : 04 77 49 75 80
> > _______________________________________________
> > ParaView mailing list
> > ParaView at paraview.org
> > http://www.paraview.org/mailman/listinfo/paraview
> >
> >
> >
>
>