[Paraview] Cut Offset Values

Berk Geveci berk.geveci at gmail.com
Mon Feb 7 09:18:44 EST 2005


Can you elaborate a bit? It works ok for me. I believe the offset
value is the distance from the surface of the actual sphere. I didn't
check but the default range provided by paraview might be wrong. If
this is the case, please file a bug report here:

http://www.paraview.org/Bug/


On Mon, 7 Feb 2005 14:14:53 +0100, Thierry Dubuis
<tdubuis at scconsultants.com> wrote:
>  
> Hello, 
>   
> I try to use Cut Offset values to define multiple cut spheres with centered
> shifted. 
> As it's explain page 219 of "The ParaView Guide" but I can't. 
> The cut planes are Ok but not the Cut spheres. 
>   
> Is it a definition or visualisation problem ? 
> Could you explain me which parameter change between 2 "multiple cuts" ? (For
> the cut plane, it's the center) 
>   
> Thanks for your help. 
> -----------------------------------------------------
> Thierry Dubuis
> Sciences & Computer Consultants
> Tel Dir  : 04 77 49 75 84
> Tel Std : 04 77 49 75 80 
> _______________________________________________
> ParaView mailing list
> ParaView at paraview.org
> http://www.paraview.org/mailman/listinfo/paraview
> 
> 
>


More information about the ParaView mailing list