[Midas] Fwd: How to build ParaViewWeb with Slicer

[Sebastien Jourdain]

Sure, you can start with that:
http://paraview.org/Wiki/ParaView:Build_And_Install

But what you want to achieve is not something that is available directly.
You will need some small development on your end.

Seb


On Tue, Oct 22, 2013 at 6:29 AM, Ferdinando Primerano <
f.primerano90 at gmail.com> wrote:

> Hi Sebastien,
>
> Can you give me some guide to follow please?
> As I said I tried to setup an Apache front-end but it gives me an error
> during the compilation with 'make'.
> Supposing I can fix that somehow, how should I import only the slicer to
> my web page?
>
> Thank you again for your patience.
>
> Ferdinando
>
>
>
> 2013/10/21 Sebastien Jourdain <sebastien.jourdain at kitware.com>
>
>> Hi Ferdinando,
>>
>> If you want to achieve that on your end, you will definitely need to
>> build ParaView or VTK with the Python wrapping in order to enable the Web
>> support.
>> But after that, depending on your setup, you may need to setup an Apache
>> front-end to deal with the Websocket forwarding and some virtual host to
>> allow both your tomcat and our Session manager to respond within the same
>> domain.
>>
>> Seb
>>
>>
>> On Mon, Oct 21, 2013 at 2:31 PM, Ferdinando Primerano <
>> f.primerano90 at gmail.com> wrote:
>>
>>>
>>>
>>> ---------- Forwarded message ----------
>>> From: Ferdinando Primerano <f.primerano90 at gmail.com>
>>> Date: 2013/10/21
>>> Subject: How to build ParaViewWeb with Slicer
>>> To: midas at public.kitware.com
>>>
>>>
>>> Hi,
>>>
>>> I am new to ParaView and I am trying to use ParaViewWeb inside a website
>>> based on Apache Tomcat.
>>> In particular I would like to obtain this slicer:
>>> http://50.58.123.185/external/midas/visualize/paraview/slice?itemId=44
>>> and call it from my pages.
>>>
>>> I was searching through the internet about this but with no success.
>>> I tried to build ParaViewWeb as shown in this guide
>>> http://www.paraview.org/ParaView3/Doc/Nightly/www/js-doc/index.html#!/guide/apache_setup
>>> but I obtained an error while compiling with 'make' which gives problem
>>> with "all" and "default_target" after this point:
>>> [ 58%] Built target vtkEyeDomeLightingCS
>>>
>>> I'm not sure I'm doing the right thing for my goal, can you help me with
>>> this please?
>>>
>>> Thank you in advance.
>>>
>>> Best regards,
>>>
>>> Ferdinando
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> Midas mailing list
>>> Midas at public.kitware.com
>>> http://public.kitware.com/cgi-bin/mailman/listinfo/midas
>>>
>>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/midas/attachments/20131022/42c7036d/attachment.html>