[vtkusers] Re move unwanted inner mesh inside an enclosed mesh

[Bill Lorensen]

This is an even better way to do it:
http://www.vtk.org/Wiki/VTK/Examples/PolyData/ExtractOutsideSurface

Bill

On Thu, May 13, 2010 at 10:41 AM, Bill Lorensen <bill.lorensen at gmail.com> wrote:
> If there is only one outer mesh, you can use
> vtkPolyDataConnectivityFilter and extract the largest region.
>
> This example illustrates one use of the filter
>
> http://www.vtk.org/Wiki/VTK/Examples/PolyData/vtkPolyDataConnectivityFilter_LargestRegion
>
>
> On Wed, May 12, 2010 at 11:26 AM, superzz <jxdw_zlf at yahoo.com.cn> wrote:
>>
>> Hello
>> I am using marching cube to build 3d mesh. But I found there are lots of
>> inner mesh inside the outter mesh. The outter mesh is ensured to be
>> enclosed.
>>
>> Is there any way to remove those inner meshes inside the outter mesh?
>>
>> I tried use vtkCutter to generate contour, use ImageStencilWithPolydata to
>> get all image regions inside mesh. But finally I realised that none of them
>> can be applied in this case.
>>
>> Thanks
>>
>> superZZ
>> --
>> View this message in context: http://old.nabble.com/Remove-unwanted-inner-mesh-inside-an-enclosed-mesh-tp28537482p28537482.html
>> Sent from the VTK - Users mailing list archive at Nabble.com.
>>
>> _______________________________________________
>> Powered by www.kitware.com
>>
>> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>>
>> Please keep messages on-topic and check the VTK FAQ at: http://www.vtk.org/Wiki/VTK_FAQ
>>
>> Follow this link to subscribe/unsubscribe:
>> http://www.vtk.org/mailman/listinfo/vtkusers
>>
>