[vtkusers] vtkCone() and vtkCutter

[tartoussi hadi]

Hi all,

I have a structured grid of a radial turbine and i am trying to do several cuts perpendicular to the hub using vtkCone() and vtkCutter() and then i generate an unstructured grid slice.
But i noticed that when the angle of the cone is high (the center of the cone is close to the grid domain), the unstructured grid slice is very deformed. So i tried to translate my  grid domain far away from the center of the slice and reproduce the cut, this works fine. 
So i guess that the tip of the cone is not well defined . Is there a possibility to increase the resolution of the cone as in ConeSource()?
Please find attached a screenshot of the cone slice.

Thanks in advance,
Regards,
Hadi



      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vtk.org/pipermail/vtkusers/attachments/20100609/d52e5330/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: visu1.jpg
Type: image/jpeg
Size: 27771 bytes
Desc: not available
URL: <http://www.vtk.org/pipermail/vtkusers/attachments/20100609/d52e5330/attachment.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: visu2.jpg
Type: image/jpeg
Size: 107495 bytes
Desc: not available
URL: <http://www.vtk.org/pipermail/vtkusers/attachments/20100609/d52e5330/attachment-0001.jpg>