[vtkusers] Unrolling a vtkCylinder

[Sarah Macumber]

Yes, but I have scalar data on the cylinder that I want to preserve when
I unroll it.

Sarah

*************************************************************

-----Original Message-----
From: cquammen at gmail.com [mailto:cquammen at gmail.com] On Behalf Of Cory
Quammen
Sent: Tuesday, April 29, 2008 9:26 PM
To: Sarah Macumber
Cc: vtkusers at vtk.org
Subject: Re: [vtkusers] Unrolling a vtkCylinder

If you need a plane, you could use vtkPlaneSource.

Cory

On Tue, Apr 29, 2008 at 3:33 PM, Sarah Macumber
<S.Macumber at questreliability.com> wrote:
>
>
>
>
> Is there any way to flatten or unroll a vtkCylinder so that it's a
plane or
> structured grid?
>
>
>
> Thanks Sarah
>
>
>
> *************************************************************
>
> Sarah Macumber, Engineer
>
>
>
> Quest Reliability, LLC
>
> 2465 Central Avenue, Suite 110
>
> Boulder, Colorado  80301
>
> direct line: (303) 938-3024
>
> office line: (303) 415-1475   FAX: (303) 415-1847
>
> web: http://www.QuestReliability.com
>
>
> _______________________________________________
>  This is the private VTK discussion list.
>  Please keep messages on-topic. Check the FAQ at:
> http://www.vtk.org/Wiki/VTK_FAQ
>  Follow this link to subscribe/unsubscribe:
>  http://www.vtk.org/mailman/listinfo/vtkusers
>
>



-- 
Cory Quammen
Department of Computer Science
University of North Carolina at Chapel Hill
http://www.cs.unc.edu/~cquammen