[vtkusers] vtkCardinalSpline Interpolation

[Lino Ramirez]

Dear Bill,

Thank you very much for your reply. Yes, I was asking about tension
control. I will try out the vtkKochanekSpline class as you suggested.

Thanks again,

Lino

> This class interpolates the input data. It will always pass through the
> points. If you are asking about tenson control, then you can use
> vtkKochaneckSpline
> .
> -----Original Message-----
> From: vtkusers-bounces+lorensen=crd.ge.com at vtk.org
> [mailto:vtkusers-bounces+lorensen=crd.ge.com at vtk.org]On Behalf Of Lino
> Ramirez
> Sent: Tuesday, May 17, 2005 5:23 PM
> To: vtkusers at vtk.org
> Subject: [vtkusers] vtkCardinalSpline Interpolation
>
>
> Hello All,
>
> In the vtkCardinalSpline, how do I control how loosely or tightly the
> cardinal spline fits the input control points?
>
> Thank you,
>
> Lino
>
> _______________________________________________
> This is the private VTK discussion list.
> Please keep messages on-topic. Check the FAQ at:
> http://www.vtk.org/Wiki/VTK_FAQ
> Follow this link to subscribe/unsubscribe:
> http://www.vtk.org/mailman/listinfo/vtkusers
>