[vtkusers] a sinple question about vtkMarchingcubes

[Lorensen, William E (CRD)]

Look at :
http://www.crd.ge.com/~lorensen/seg12/

Bill

> -----Original Message-----
> From:	Amy Henderson [SMTP:amy.henderson at kitware.com]
> Sent:	Monday, December 04, 2000 4:35 PM
> To:	Wenqin Wang; vtkusers at public.kitware.com
> Subject:	Re: [vtkusers] a sinple question about vtkMarchingcubes
> 
> At 01:25 PM 12/4/2000 -0800, Wenqin Wang wrote:
> >Hi, all,
> >   I am new in VTK. I am trying to visualize a volume
> >in VTK. The valume is already segmented, with one
> >value is 100, and the other is 200. What I tried to do
> >is to extract those two surfaces using marching cubes.
> >
> >   But I cann't understand how to set the value for the
> >marching cubes, the value I should use is 50.0 or
> >100.0?
> 
> Use 100.0 and/or 200.0 (depending on which surface(s) you are trying to 
> extract).
> 
> Amy
> 
> >   Thanks for help.
> >
> >   Wendy
> >
> >__________________________________________________
> >Do You Yahoo!?
> >Yahoo! Shopping - Thousands of Stores. Millions of Products.
> >http://shopping.yahoo.com/
> >
> >_______________________________________________
> >This is the private VTK discussion list.
> >Please keep messages on-topic. Check the FAQ at: 
> ><http://public.kitware.com/cgi-bin/vtkfaq>
> >Follow this link to subscribe/unsubscribe:
> >http://public.kitware.com/mailman/listinfo/vtkusers
> 
> 
> _______________________________________________
> This is the private VTK discussion list. 
> Please keep messages on-topic. Check the FAQ at: <http://public.kitware.com/cgi-bin/vtkfaq>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/vtkusers