[Paraview] Interpolation error in paraview

[HongchaoWang]

Hi,

 

Besides the question below, is the filter "point interpolation" is used for
more advanced interpolation scheme? Can I use this filter to obtain more
accurate interpolation result? Anyone who could explain this filter to me? I
just couldn't find any tutorial on this filter.

 

Many thanks,

Wilson

 

 

From: HongchaoWang [mailto:hongchao.wang2013 at gmail.com] 
Sent: Friday, 18 August 2017 11:37 AM
To: 'paraview at paraview.org' <paraview at paraview.org>
Subject: Interpolation error in paraview

 

I'm just wondering what interpolation scheme is used for data manipulation
in Paraview?

 

I'm using Paraview 5.2.0. I want to measure the velocity very close to a
wall surface so that I can obtain the wall shear stress. However, I found
the velocity measured using Paraview is different from the results I have
obtained using the postprocessing tool in OpenFoam. Compared with the
analytical solution which is already known in my case, Paraview result is
worse and is 10% smaller than the analytical solution while the OpenFoam
result agrees with the analytical solution very well. With finer mesh, the
difference between the Paraview and OpenFoam results becomes smaller, so I
believe the difference is due to the interpolation error.

 

Anyone who has experience on this problem? Is there any advanced
interpolation scheme that I can use in Paraview?

 

 

Many thanks,

Wilson  

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/paraview/attachments/20170819/06396f3f/attachment.html>