[Paraview] QuadView option

[Sebastien Jourdain]

Hi Michael,

I don't think there is such option.
In fact, this must be due to the representation be set to "Outline" in the
toolbar.
If you change it to Surface of Wireframe you should not see anymore the
outline.

Seb


On Thu, Sep 4, 2014 at 8:09 AM, Reuter, Michael A. <reuterma at ornl.gov>
wrote:

> Hi,
>
> I’m looking for the option that turns off the outline in the 3D panel in
> the Quad View in ParaView git-master. This used to be in the view settings
> dialog, but that no longer exists and the settings dialog doesn’t seem to
> have it unless I missed it. The Slice View has a similar option in the
> Properties panel under Background, but nothing appears there for the Quad
> View.
>
> Thanks,
> M
>
> Dr. Michael Reuter
> Scientific Data Analysis Group
> Neutron Data Analysis and Visualization Division
> Oak Ridge National Laboratory
>
> Office: 1-865-241-7216
> Fax: 1-865-574-6080
> Email: reuterma at ornl.gov<mailto:reuterma at ornl.gov>
>
>
>
>
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/paraview
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/paraview/attachments/20140904/6b285d38/attachment.html>