[Paraview] Setting default Glyph Type to Sphere

[Cory Quammen]

Tom,

No, there is not a way to tell that at this time.

Cory

On Wed, Oct 1, 2014 at 8:50 AM, Thomas O'Toole
<Thomas.Otoole at pinntech.com> wrote:
> Cory,
>
> OK, thanks for this information. On a related note, is there an easy way of telling which properties can/cannot presently have custom defaults set?
>
> Cheers,
>
> Tom
>
> -----Original Message-----
> From: Cory Quammen [mailto:cory.quammen at kitware.com]
> Sent: 01 October 2014 13:46
> To: Thomas O'Toole
> Cc: paraview at paraview.org
> Subject: Re: [Paraview] Setting default Glyph Type to Sphere
>
> Tom,
>
> Alas, the settings custom defaults work for most, but not all properties. This is one of those properties for which it does not work, unfortunately. One of my goals for the next release is to make custom defaults work for properties such as these.
>
> Best regards,
> Cory
>
> On Wed, Oct 1, 2014 at 7:38 AM, Thomas O'Toole <Thomas.Otoole at pinntech.com> wrote:
>> Hi everyone,
>>
>>
>>
>> I would like to set the Glyph filter Glyph Type to be Sphere by default.
>> I’ve read through the blog post about setting defaults in Paraview 4.2
>> (http://www.kitware.com/blog/home/post/702) but have been unsuccessful
>> in my attempts to set this default either through the GUI or using a
>> JSON config file.
>>
>>
>>
>> Is it possible to set the Glyph Type to be Sphere by default? And if
>> so, what JSON syntax is needed to achieve this?
>>
>>
>>
>> Many thanks,
>>
>>
>>
>> Tom
>>
>>
>>
>>
>>
>> ________________________________
>> This e-mail, including any attached files, may contain confidential
>> and privileged information for the sole use of the intended recipient.
>> Any review, use, distribution, or disclosure by others is strictly prohibited.
>> If you are not the intended recipient (or authorized to receive
>> information for the intended recipient), please contact the sender by
>> reply e-mail and delete all copies of this message.
>>
>> _______________________________________________
>> Powered by www.kitware.com
>>
>> Visit other Kitware open-source projects at
>> http://www.kitware.com/opensource/opensource.html
>>
>> Please keep messages on-topic and check the ParaView Wiki at:
>> http://paraview.org/Wiki/ParaView
>>
>> Follow this link to subscribe/unsubscribe:
>> http://public.kitware.com/mailman/listinfo/paraview
>>