[Paraview] Bad proxy for lookup table

[Utkarsh Ayachit]

Anton,

The lookup table would be setup only if scalar coloring was employed.
Some reason the code is deciding to pick scalar coloring for the
dataset when being shown in render view, but not so for
pqMultiSliceView. What version of ParaView is this?

Utkarsh



On Fri, Dec 19, 2014 at 4:32 AM,  <Anton.Piccardo-Selg at tessella.com> wrote:
> Dear all,
>
> When I ask for a lookup table from my representation
>
> pqScalarsToColors *lut = repr->getLookupTable();
>
> I get a NULL pointer for lut for some data sets. It seems that the proxy to
> get the lookup table does not exist in this case. The same type of data set,
> yet with different entries does not show these issues. I should mention that
> this only happens when the view is a  pqMultiSliceView, not in the
> pqRenderView.
>
> Has anyone seen such a behaviour or knows what the cause of this could be?
>
> Many thanks and best regards,
>
> Anton
>
> This message is commercial in confidence and may be privileged. It is
> intended for the
> addressee(s) only. Access to this message by anyone else is unauthorized and
> strictly prohibited.
> If you have received this message in error, please inform the sender
> immediately. Please note that
> messages sent or received by the Tessella e-mail system may be monitored and
> stored in an
> information retrieval system.
>
>
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/paraview
>