[Paraview] Error with Qt while installing Paraview

[Yumin Yuan]

Also, the QT_QMAKE_EXECUTABLE variable Utkarsh was talking about is a
CMake varialble. Try to set that variable at cmake configure step.

HTH,
Yumin

On Mon, Jan 7, 2013 at 9:52 AM, Utkarsh Ayachit
<utkarsh.ayachit at kitware.com> wrote:
> Qt 5 isn't supported  yet. Stick with 4.8.*. Although I am sure we
> will support Qt 5.0 at some point, right now there is no active effort
> to add support for the same.
>
> Utkarsh
>
> On Fri, Jan 4, 2013 at 6:42 PM, Pradeep Jha <pradeep.kumar.jha at gmail.com> wrote:
>> Hello,
>>
>> I set the environment variable QT_QMAKE_EXECUTABLE in my .bashrc file to
>> point to the qmake executable. In the installed Qt5.0.0 folder, I found only
>> one qmake executable which was at /path_to_Qt5.0.0/5.0.0/clang_64_bin/. But
>> still I am getting the same error. Any further ideas?
>>
>> Thank you,
>> Pradeep
>>
>>
>> 2013/1/4 Utkarsh Ayachit <utkarsh.ayachit at kitware.com>
>>>
>>> Try setting the QT_QMAKE_EXECUTABLE variable to point to the right
>>> qmake executable installed by Qt.
>>>
>>> On Fri, Jan 4, 2013 at 5:01 AM, Pradeep Jha <pradeep.kumar.jha at gmail.com>
>>> wrote:
>>> > QT_QMAKE_EXECUTABLE
>>
>>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview