[Paraview] Where is "Apply Texture" located in ParaView 3.98.1?

[Burlen Loring]

Hi,

I recently struggled with that too, and finally after some 
experimentation found out one way. Seems that the feature is now enabled 
by some filters. Best to illustrate by example:

Create a Sphere Source
Apply Texture Map To Sphere Filter
In the Properties Panel there is a Texture Field, select "load..." from 
its drop down.

That should get you a textured sphere, and hopefully you can bootstrap 
to your desired use case.

Unfortunately in my case data is large and I need to run in parallel and 
the texture was not applied correctly. Hopefully you have small data and 
run PV in serial if you need that feature.

Burlen

On 04/03/2013 12:19 PM, Hom Nath Gharti wrote:
> Dear all,
>
> In earlier versions there was "Apply Texture" in Display tab. I cannot 
> see this in 3.98.1. Where can I find it? Or is it changed to something 
> else?
>
> Thanks,
> Hom Nath
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20130403/d3884b4c/attachment-0001.htm>