[Paraview] [EXTERNAL] Re: show only edges?

[Moreland, Kenneth]

Or if you are only interested in viewing you could just change the display to wireframe, which only shows the edges on the surface.

-Ken

Sent from my iPad so blame autocorrect.

On May 29, 2012, at 6:56 AM, "David E DeMarle" <dave.demarle at kitware.com<mailto:dave.demarle at kitware.com>> wrote:

Extract Surface->Extract Edges?

David E DeMarle
Kitware, Inc.
R&D Engineer
21 Corporate Drive
Clifton Park, NY 12065-8662
Phone: 518-881-4909


On Tue, May 29, 2012 at 9:50 AM, Nico Schlömer <nico.schloemer at gmail.com<mailto:nico.schloemer at gmail.com>> wrote:
Hi all,

I have this tetrahedron as a VTK file. Is there any way to just
display its edges? I found the "Extract Edges" filter, but that show
all the edges of the discretization (whereas I'm only interested in
the edges of the geometry).

Cheers,
Nico
_______________________________________________
Powered by www.kitware.com<http://www.kitware.com>

Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html

Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView

Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview

_______________________________________________
Powered by www.kitware.com<http://www.kitware.com>

Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html

Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView

Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20120529/e4d1df66/attachment.htm>