[Paraview] Multiple Point selection error

[Utkarsh Ayachit]

Looks like you compiled version is 3.14-RC2. Try updating. Not sure if
the issue was resolved since the RC2.

Utkarsh

On Thu, Feb 23, 2012 at 10:01 AM, Abdullahi Sanusi
<scontact101 at gmail.com> wrote:
> Hi Utkarsh,
> Multiple point selection worked fine just the way it appears on the
> screenshot you attached only when I am using the installable (.exe)
> version but not the source that I compiled. However, I need to work on
> my own build version to enable me extend it functionality to achieve
> my project aim. Please see attached screenshots for the errors.
> Cheers.
>
>
>
> On 2/22/12, Utkarsh Ayachit <utkarsh.ayachit at kitware.com> wrote:
>> Works for me (Screenshot attached). Any additional details to
>> reproduce the issue?
>>
>>
>>
>> On Wed, Feb 22, 2012 at 12:51 PM, Abdullahi Sanusi
>> <scontact101 at gmail.com> wrote:
>>> Hi All,
>>>
>>> Whenever I try to select more than point using Select Points On + holding
>>> down the ctrl key and using mouse to pick pick points I get this error
>>> Generic Warning: In
>>> C:\ParaView-3.14.0\ParaViewCore\ServerManager\vtkSMPropertyHelper.cxx,
>>> line
>>> 399
>>>
>>> Call not supported for the current property type
>>>
>>> Please help.
>>>
>>>
>>> _______________________________________________
>>> Powered by www.kitware.com
>>>
>>> Visit other Kitware open-source projects at
>>> http://www.kitware.com/opensource/opensource.html
>>>
>>> Please keep messages on-topic and check the ParaView Wiki at:
>>> http://paraview.org/Wiki/ParaView
>>>
>>> Follow this link to subscribe/unsubscribe:
>>> http://www.paraview.org/mailman/listinfo/paraview
>>>
>>