[Paraview] How to design 3D picture.

[Russell M. Taylor II]

If I understand your original question correctly, it sounds like you 
want to exaggerate the Z scale with respect to X and Y so that you 
can see your data better.

There are a couple of ways to do that.  The more general way would be 
to apply a Transform filter to your data after it is input, changing 
the scale on the Z axis to be higher than 1.  This has the benefit of 
following through to all future visualizations extracted from that data set.

The second approach is to adjust the Z scale on the Display tab for 
every visualization you produce, again adjusting the Z axis scale to 
be larger than 1.

Russ


---
Russell M. Taylor II, Ph.D.                           taylorr at cs.unc.edu
CB #3175, Sitterson Hall                        www.cs.unc.edu/~taylorr
University of North Carolina,                     Voice: (919) 962-1701
Chapel Hill, NC 27599-3175                        FAX:   (919) 962-1799