[Paraview] What data type to set to show 2D Plot (Line Chart)

[Michael Jackson]

Thanks. 
  I give that a try and see what happens.
--
Mike Jackson <www.bluequartz.net>

On Oct 11, 2011, at 3:00 PM, Eric E. Monson wrote:

> I don't know about readers, but some of the filters have a section of their XML that specifies a Chart view preference:
> 
>     <Hints>
>        <!-- View can be used to specify the preferred view for the proxy -->
>        <View type="XYChartView" />
>        <Plotable />
>     </Hints>
> 
> -Eric
> 
> · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · ·
> Eric E Monson
> Duke Visualization Technology Group
> 
> 
> On Oct 11, 2011, at 1:37 PM, Michael Jackson wrote:
> 
>> I have a custom reader for ParaView that has multiple output ports. On 2 of those ports are "vtkTable" data types. This all works just fine and reads ok. The issue is when I open the data file in ParaView I get 2 different views each with a "Spreadsheet". Is there any way to tell ParaView that those data sets should be displayed as Line Charts instead of the Spreadsheet view? Or is there a reader that does this already? If so I'll look at that code and figure it out. 
>> 
>> Thanks
>> ___________________________________________________________
>> Mike Jackson                    Principal Software Engineer
>> BlueQuartz Software                            Dayton, Ohio
>> mike.jackson at bluequartz.net              www.bluequartz.net
>> 
>> _______________________________________________
>> Powered by www.kitware.com
>> 
>> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>> 
>> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>> 
>> Follow this link to subscribe/unsubscribe:
>> http://www.paraview.org/mailman/listinfo/paraview
>