[Paraview] Data does not load off of a partition from saved (.wind) state

[Sohail Shafii]

It appears that this problem also happens when I put the data on the root partition.  For some reason when ParaView restores the state, wind blade reader thinks it's being told to load in the "Density" array, and not the "UVW" array as I specified.  I can't seem to load in the UVW array after paraview starts either...this only happens when trying to restore a state for this data set (i.e. not when I open the data set without loading a state). This doesn't happen with other .wind data sets, only this new fairly large one (which is about 600 MB per time step).

Sohail



________________________________
 From: Sohail Shafii <sohailshafii at yahoo.com>
To: "paraview at paraview.org" <paraview at paraview.org> 
Sent: Thursday, November 17, 2011 2:52 PM
Subject: Data does not load off of a partition from saved (.wind) state
 

Hi,

I've noticed that if I open a data set from a separate partition (after mounting it in Linux), and if I save a state file related to said data set, the data does not load at all when I load the statefile if after I start ParaView from a clean state.  Please note that it doesn't matter if the state file is saved on my root partition or on the separate partition. Also, this is specific to the wind blade reader.  I've debugged it and it appears to be reading the data when loading the saved state...for some reason that information does not get passed to the ParaView pipeline.

The end result is that I have a Field, Blade and Ground ports except all three have zero points and cells. This is for the release branch of ParaView.


Any thoughts? Thanks.

Sohail
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20111120/7815cce8/attachment.htm>