[Paraview] How to get rpath set

[Cook, Rich]

I know there is a religious answer to this, but I want to have rpath set in my binaries after install, for our osmesa backends.  I'm wrong and bad for this, I accept all blame and shame, but I want to do it anyhow.  The default Paraview install stubbornly insists on stripping all the rpaths out at install time, which is quite depressing.  Even worse, I know I've asked this before and I cannot find an answer in my archives or with Google.  :-(
What would be the easiest way to do this?  Can I do this by setting a CMake variable?  
Thanks!  

-- 
✐Richard Cook   
✇ Lawrence Livermore National Laboratory
Bldg-453 Rm-4024, Mail Stop L-557        
7000 East Avenue,  Livermore, CA, 94550, USA
☎ (office) (925) 423-9605    
☎ (fax) (925) 423-6961
---
Information Management & Graphics Grp., Services & Development Div., Integrated Computing & Communications Dept.
(opinions expressed herein are mine and not those of LLNL)