[Paraview] slice + stream tracer only on 1/2 of the slice

[Utkarsh Ayachit]

You could clip the data instead of slice and then stream-trace the
clipped part.

Utkarsh

On Mon, Jan 10, 2011 at 9:54 AM, Stephen Wornom <stephen.wornom at inria.fr> wrote:
> I make a z-slice of 3D data. I would like to use stream tracer only on the
> top 1/2. How do I do this?
> Thanks if advance,
> Stephen
>
> --
> stephen.wornom at inria.fr
> 2004 route des lucioles - BP93
> Sophia Antipolis
> 06902 CEDEX
>
> Tel: 04 92 38 50 54
> Fax: 04 97 15 53 51
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>
>