[Paraview] How to prevent rendering after adding a filter

[Michael Robinson]

Problem: When building a long pipeline on a large dataset, the rendering 
of the result from each added filter takes a long time, for an intermediate 
result that is of no interest.

Question: Is there a way to force ParaView (3.10.1) to use "Outline" 
representation for each added filter?  Or perhaps to default to "Off" 
visibility?

Sure would be handy!  Thanks!

Michael A. Robinson
Kratos/Digital Fusion
5030 Bradford Drive
Huntsville, AL  35805
256-327-8139  (Voice)
***NOTICE*** This e-mail and/or the attached documents may contain
technical data within the definition of the International Traffic
in Arms Regulations and/or Export Administration Regulations, and
are subject to the export control laws of the U.S. Government.
Transfer of this data by any means to a foreign person, whether in
the United States or abroad, without an export license or other
approval from the U.S. Department of State or Commerce, as
applicable, is prohibited. No portion of this e-mail or its
attachment(s) may be reproduced without written consent of Kratos
Defense & Security Solutions, Inc. Any views expressed in this
message are those of the individual sender, except where the
message states otherwise and the sender is authorized to state them
to be the views of any such entity. The information contained in
this message and or attachments is intended only for the person or
entity to which it is addressed and may contain confidential and/or
privileged material. If you are not the intended recipient or
believe that you may have received this document in error, please
notify the sender and delete this e-mail and any attachments
immediately.