[Paraview] Issue with Slice filter & plane source

[Adriano Gagliardi]

I've come across a strange issue with the Slice filter. Admittedly, I am
using an older version of ParaView (3.6.2) but, before I go through the
process of getting 3.10 compiled again, I wondered if anyone has also had
this problem. Essentially, when I wish to take a slice using a plane source,
the bounding box I can move the slice widget within does not capture the
entire geometry. However, if I manually click on the slice normal and
location in the filter panel it works. Also, using the slice offset values
also works fine. Finally, both the sphere and box sources correctly
determine the bounds of the data-set. I am testing this out on a new reader
I created recently, and I'm wondering if there is something I've missed out?
Notably, the bounds of the test geometry I'm reading in for X, Y, and Z
dimensions is 0 to 1, but this should really matter.

Has anyone come across this issue before?

Regards,

Adriano

===================================

Adriano Gagliardi MEng PhD
Business Sector Leader
Computational Aerodynamics
Aircraft Research Association Ltd.
Manton Lane
Bedford

Tel: 01234 32 4644
E-mail: agagliardi at ara.co.uk
Url: www.ara.co.uk 


**********************************************************************
This email contains information that is private and confidential and is intended only for the addressee.
If you are not the intended recipient please delete it and notify us immediately by e-mailing the sender.
Note: All email sent to or from this address may be accessed by someone other than the recipient, for
system management and security reasons.
Aircraft Research Association Ltd.  Registered in England, Registration No 503668 Registered Office:
Manton Lane, Bedford MK41 7PF England VAT No GB 196351245

**********************************************************************