[Paraview] Probe Location

[Utkarsh Ayachit]

You need to hit "Apply" after having positioned the probe filter at
the location you want. After that the "Information' tab will update.

Utkarsh

On Tue, Oct 19, 2010 at 12:16 PM, Phil Tiller <ptiller at lolacars.com> wrote:
>
> Hi,
>
> I've been trying to use the 'probe location' filter to extract values at
> certain points.  How does this work?  I find that if I bring the filter
> up and enter a position then I can see the point displayed at the
> position that I wanted.  When I go to the information tab, the data at
> this position is not there.  I've found that I can randomly get the data
> to appear on the information tab but I've not been able to work out what
> I did to achieve this.  I must have refreshed the graphics or page
> somehow but most times I can't get the data out.
>
> Any ideas?
>
> Thanks,
>
> Phil
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> ______________________________________________________________________
> This email has been scanned for viruses by www.epagency.net
> If you consider this email spam, please forward it to spam at epagency.net
> ______________________________________________________________________
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>