[Paraview] Paraview: python script from the command line

[Rick Angelini]

Do I still get the GUI if I us pvpython or vtkpython?  I'm looking to 
jumpstart the Paraview GUI using a python script.

Andy Bauer wrote:
> You're probably looking for pypython but vtkpython may also work.
>
>
> On Fri, Mar 19, 2010 at 3:42 PM, Rick Angelini 
> <rick.angelini at us.army.mil <blockedmailto:rick.angelini at us.army.mil>> 
> wrote:
>
>     Is there a way to startup paraview and have it run a python script
>     from the command line?   I know that I can load a state with the
>     "--state" flag.    And, I can run a python script from within
>     ParaView by going to the python tool and running the script.    
>     As far as I can tell, I'm limited to running the python script
>     after ParaView GUI starts up.    It would be nice to be able to
>     load that same script from the command line.
>     _______________________________________________
>     Powered by www.kitware.com <blockedhttp://www.kitware.com>
>
>     Visit other Kitware open-source projects at
>     http://www.kitware.com/opensource/opensource.html
>     <blockedhttp://www.kitware.com/opensource/opensource.html>
>
>     Please keep messages on-topic and check the ParaView Wiki at:
>     http://paraview.org/Wiki/ParaView
>     <blockedhttp://paraview.org/Wiki/ParaView>
>
>     Follow this link to subscribe/unsubscribe:
>     http://www.paraview.org/mailman/listinfo/paraview
>     <blockedhttp://www.paraview.org/mailman/listinfo/paraview>
>
>