[Paraview] Cell-centered data with vtkTecplotReader

[Adriano Gagliardi]

Dear All,

I've got a Tecplot file containing cell-centered data, which is working fine
with Tecplot. However, ParaView doesn't recognise the file header:

====tecplot file header begin====
TITLE     = "FLOWFIELD"
VARIABLES = "X" "Y" "Z" "RHO" "U" "V" "W" "CP" "P"
ZONE T="BLOCK 1", I=35, J=39, K=105, ZONETYPE=Ordered, DATAPACKING=BLOCK,
VARLOCATION=([4-9]=CELLCENTERED)
====tecplot file header end====
====data-layout====
====all X values====
====all Y values====
====all Z values====
====etc====

Should this data-set be supported? If not, can someone describe which are
not supported? I'd prefer to avoid using Tecplot for the post-processing,
but I may not have much choice in the matter.

Regards,

Adriano

===================================

Adriano Gagliardi MEng PhD
Business Sector Leader
Computational Aerodynamics
Aircraft Research Association Ltd.
Manton Lane
Bedford

Tel: 01234 32 4644
E-mail: agagliardi at ara.co.uk
Url: www.ara.co.uk 


**********************************************************************
This email contains information that is private and confidential and is intended only for the addressee.
If you are not the intended recipient please delete it and notify us immediately by e-mailing the sender.
Note: All email sent to or from this address may be accessed by someone other than the recipient, for
system management and security reasons.
Aircraft Research Association Ltd.  Registered in England, Registration No 503668 Registered Office:
Manton Lane, Bedford MK41 7PF England VAT No GB 196351245

**********************************************************************